Rukus Wireless ZoneFlex 7731 Betriebsanweisung PDF herunterladen (Seite 36)

Installing the Access Point

Step 1: Preconfigure the Access Point

The procedure for completing the Access Point’s essential configuration depends on

whether you want it to be managed by either ZoneDirector or FlexMaster or to operate

as a standalone Access Point. Refer to the section that is relevant to your deployment:

■ Configuring for Management by ZoneDirector

■ Configuring for Standalone Operation or for Management by FlexMaster

Configuring for Management by ZoneDirector

If ZoneDirector is installed on the network, you do not need to preconfigure the Access

Point for management by ZoneDirector. Simply connect the Access Point to same

Layer 2 subnet as ZoneDirector, and when the Access Point starts up, it will discover

and register with ZoneDirector automatically.

NOTE: In addition to using Layer 2 auto discovery to enable the Access Point to

information, refer to the ZoneDirector User Guide.

CAUTION: If you use this method, make sure that you do not change the IP address

of ZoneDirector after the AP discovers and registers with it. If you change the

ZoneDirector IP address, the AP will no longer be able to communicate with it and

will be unable to rediscover it.

CAUTION: If you configure an AP for management by ZoneDirector and later decide

that you want it to be a standalone AP, you will need to factory reset the AP.

Before starting this procedure, check the label on the back panel of the Access Point,

and write down the MAC address of the Access Point. You will need the MAC address

to identify the Access Point on the ZoneDirector Web interface.

What You Will Need

Before starting with the configuration task, make sure that you have the following

requirements ready:

■ A computer from which you can access the ZoneDirector Web interface

■ A Web browser such as Google Chrome, Mozilla Firefox 2.0 (or later) or Microsoft

Internet Explorer 6.0 (or later) installed on the administrative computer

■ One Cat5e foil screened twisted pair (FTP) solid Ethernet cable

■ Your ZoneFlex Access Point and its power adapter (or a PoE injector/PoE switch

to supply Power Over Ethernet to the Access Point)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 119 120

Keine Kommentare

Rukus Wireless ZoneFlex 7731 Betriebsanweisung Seite 36