Rukus Wireless ZoneFlex 7731 Betriebsanweisung PDF herunterladen (Seite 84)

Configuring the Access Point

Configuring Ethernet Ports

Port Type See “Setting Ethernet Port Type” on page 77 for

more detailed information.

■ Trunk port: This port passes all VLAN traffic.

■ Access Port: This port provides network

access.

■ General Port: User-defined VLAN member-

ship.

Packet Forwarding Isolated: Selecting Isolated causes the traffic

from this port to terminate at the Access Point.

Bridge to WAN: The default setting, Bridge to

WAN forwards packets arriving on this port to the

WAN (uplink) port and eventually to their external

destinations using Layer 2 forwarding.

Local Subnet NAT and Route to WAN: This

setting allows routing of packets to their

destinations using Layer 3 network address

translation (NAT).

Bridge to L2TP Tunnel: Uses Layer 2 Tunneling

Protocol to deliver packets encapsulated with an

L2TP header in UDP datagrams.

802.1X Configure the port as an 802.1X authenticator or

supplicant. The following options are available:

■ Disabled: No 802.1X controls are applied to

this port.

■ Authenticator (Port-based): Only one of the

attached MAC hosts must be authorized for

all hosts to be granted access to the network.

■ Authenticator (MAC-based): Each MAC host

is individually authenticated.

■ Supplicant: The port acts as a supplicant to

an upstream authenticator. Configure a port

as Supplicant if the port is a Trunk Port used

to connect the AP to a LAN switch.

See “Working with 802.1X on Wired Ethernet

Ports” on page 78 for more information.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 119 120

Keine Kommentare

Rukus Wireless ZoneFlex 7731 Betriebsanweisung Seite 84